How can I list the currently active clients?

The winbindd deamon can log its status to the winbind log file upon request using the signal USR2.

If debuglevel is set to 2 or above, the windbindd dameon will also print the list of clients currently active.

# killall -USR2 winbinddThe winbind log level can be set separately in the smb.conf (/etc/samba/smb.conf) file using the "log level" option, for example:

log level = 2 winbind:3Note: Reload the configuration in winbind by either sending a HUP signal to the winbindd daemon or by using "service winbind reload":

# service winbind reload

Red Hatís customer service and support teams receive technical support questions from users all over the world. Red Hat technicians add the questions and answers to Red Hat Knowledgebase on a daily basis. Access to Red Hat Knowledgebase is free. Red Hat Magazine offers a preview into the Red Hat Knowledgebase by highlighting some of the most recent entries. The information provided in this article is for your information only. The origin of this information may be internal or external to Red Hat. While Red Hat attempts to verify the validity of this information before it is posted, Red Hat makes no express or implied claims to its validity.